Woodwork

Instant Wood Adhesive

DIRECTIONS FOR USE:

1. Lightly tap the side of the bottle’s tip to let the glue exit the upper chamber.
2. Keeping the tip away from your eyes, open the bottle by cutting 3 mm (1/8″) off the tip or by using the included pin.
3. Sand and clean the parts you are gluing.
4. Spray the activator on one of the surfaces to be bonded and apply one or more drops of glue to the opposite surface.
5. Press the parts together for 10 to 15 seconds, avoiding contact with your fingers.
6. After use, keep the container away from your eyes and lightly tap the side of the bottle’s tip to remove any excess glue. Clean the tip with a disposable tissue.
7. Close the container with the attached cap, and store it in a cool, dry place, preferably below 20 °C (68 °F). Keep the container upright.

CAUTION:

The activator is flammable. Avoid use on hot surfaces and near open flames. To maintain full quality assurance, store in a cool, dry place below 20°C (68°F).
High Tech Adhesives Carpenter’s Glue. Caution: Contains cyanoacrylate. Irritates eyes and skin. In case of eye contact, flush with plenty of water and consult a doctor. Do not try to forcefully remove from skin; use acetone or nail polish remover and carefully peel off. Non-toxic. Keep out of reach of children.
The High Tech Adhesives Activator must be used in combination with High Tech Adhesives Carpenter’s Glue. It is specially formulated to accelerate the curing time of cyanoacrylate instant adhesives. The combination creates clean, ultra-fast, high-strength, and long-lasting bonds. Caution! Keep away from eyes. In case of eye contact, rinse with plenty of water for several minutes. If you wear contact lenses, remove them immediately and proceed with rinsing. Do not spray on your face. In case of accident or if you feel unwell, consult a doctor immediately.